2023年11月19日 · A powerful clean will often draw enough ink into the hose to print for a while as it uses a lot more suction than printing does. Also when you replaced the damper, did you fit a …

2023年3月1日 · Just found this page the other day and was hoping for some help. Been using a epson s60600 for the last few years at my local sign shop. Recently we've been getting …

2021年8月23日 · I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and …

2018年6月21日 · Setting the size in Summa Axis Control: It concentrates the suction to the smaller piece's width along the right side (origin side) It does not work for length so that option …

2023年11月2日 · We started the surfacing in the center and cut outward. My assumption is it had a surface tension issue that caused the whole board to buckle and it lost its suction from the …

2015年1月6日 · I have seen some units using a double spoil board where the bottom section of MDF has a X pattern to distribute the suction evenly and a second MDF sheet it laid on top of …

2011年4月5日 · Hi! We use a Mimaki JV33-160 and our vaccum setting is set to strong, but it seems there is no suction. It is obviously affecting our prints. Does anyone know what to do?

2018年5月3日 · I have a political client, that is requesting a banner print of his campaign art, to hang from a vehicle window during parades. I originally suggested vehicle magnets, as this is …

2023年1月13日 · My new Mimaki - only 5 month sold- has lost the suction power for the vacuum. So it will not hold down my material when printing... So I dont want to risk...

2010年9月9日 · Started hearing an annoying noise that I think is coming from a motor under the surface plate that sucks the material down. Suction still good but looking for suggestions as to …